装了无线网卡驱动还是用不了怎么办
Tofloor
poster avatar
5***9@qq.com
deepin
2016-03-21 02:40
Author
本帖最后由 frank0234 于 2016-3-21 16:41 编辑
  1. lspci -vvv
Copy the Code
Network controller: Qualcomm Atheros AR9462 Wireless Network Adapter (rev 01)
        Subsystem: Lite-On Communications Inc AR9462 Wireless Network Adapter
        Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- SERR- < PERR- INTx-
        Interrupt: pin A routed to IRQ 16
        Region 0: Memory at d2500000 (64-bit, non-prefetchable) [size=512K]
        Expansion ROM at d2580000 [disabled] [size=64K]
        Capabilities:
        Kernel modules: wl

  1. ifconfig
Copy the Code
enp9s0: flags=4163  mtu 1500
        inet 10.1.168.69  netmask 255.255.255.0  broadcast 10.1.168.255
        inet6 fe80::fc98:32e3:ef88:7808  prefixlen 64  scopeid 0x20
        ether 78:84:3c:95:10:76  txqueuelen 1000  (Ethernet)
        RX packets 31490  bytes 18475280 (17.6 MiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 37295  bytes 5385434 (5.1 MiB)
        TX errors 0  dropped 0 overruns 0  carrier 1  collisions 0

lo: flags=73  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        inet6 ::1  prefixlen 128  scopeid 0x10
        loop  txqueuelen 0  (Local Loopback)
        RX packets 437  bytes 36552 (35.6 KiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 437  bytes 36552 (35.6 KiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

并没有找到无线网卡的端口请问怎么办

我之前作死把原本的网卡驱动删了,想装个新的。结果驱动查了半天资料才装好,这还用不了。。。。{:4_88:}

Reply Favorite View the author
All Replies
avatar
liujianfeng
deepin
2016-03-21 21:34
#1
现在这个设备用的是wl, 你删掉bcmwl-kernel-source再看看
Reply View the author
avatar
5***9@qq.com
deepin
2016-03-21 21:54
#2
https://bbs.deepin.org/post/38234
现在这个设备用的是wl, 你删掉bcmwl-kernel-source再看看

已经卸了,然后呢
Reply View the author
avatar
5***9@qq.com
deepin
2016-03-21 21:57
#3
https://bbs.deepin.org/post/38234
现在这个设备用的是wl, 你删掉bcmwl-kernel-source再看看

变成这样了
  1. Network controller: Qualcomm Atheros AR9462 Wireless Network Adapter (rev 01)
  2.         Subsystem: Lite-On Communications Inc AR9462 Wireless Network Adapter
  3.         Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
  4.         Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- SERR-
  5.         Latency: 0, Cache Line Size: 64 bytes
  6.         Interrupt: pin A routed to IRQ 7
  7.         Region 0: Memory at d2500000 (64-bit, non-prefetchable) [size=512K]
  8.         Expansion ROM at d2580000 [disabled] [size=64K]
  9.         Capabilities:
Copy the Code
Reply View the author
avatar
liujianfeng
deepin
2016-03-21 23:57
#4

sudo modprobe ath9k
Reply View the author
avatar
5***9@qq.com
deepin
2016-03-22 00:40
#5

还是没激活
Reply View the author
avatar
liujianfeng
deepin
2016-03-22 00:50
#6

贴下demsg|grep ath 的输出
Reply View the author
avatar
5***9@qq.com
deepin
2016-03-22 01:18
#7
https://bbs.deepin.org/post/38234
贴下demsg|grep ath 的输出
  1. dmesg|grep ath
  2. [    5.287412] usbcore: registered new interface driver ath3k
Copy the Code
Reply View the author
avatar
5***9@qq.com
deepin
2016-03-22 04:38
#8
https://bbs.deepin.org/post/38234
贴下demsg|grep ath 的输出

ath3k那块是以太网卡,也就是说系统没有加载我的无线网卡,要不就是驱动没装对
Reply View the author
avatar
5***9@qq.com
deepin
2016-03-22 05:24
#9
本帖最后由 frank0234 于 2016-3-21 21:25 编辑
https://bbs.deepin.org/post/38234
贴下demsg|grep ath 的输出

重新安装了一遍驱动,这下输出如下初始化失败
  1. dmesg|grep ath
  2. [    5.434640] usbcore: registered new interface driver ath3k
  3. [    5.701344] ath: phy0: ASPM enabled: 0x42
  4. [    5.701352] ath: EEPROM regdomain: 0x6a
  5. [    5.701354] ath: EEPROM indicates we should expect a direct regpair map
  6. [    5.701357] ath: Country alpha2 being used: 00
  7. [    5.701359] ath: Regpair used: 0x6a
  8. [    5.717229] ath9k 0000:02:00.0: Failed to initialize device
  9. [    5.717383] ath9k: probe of 0000:02:00.0 failed with error -2
Copy the Code

Reply View the author
avatar
liujianfeng
deepin
2016-03-22 17:09
#10
你卸的是啥,ath9k是内核自带的模块。。。。
Reply View the author
avatar
5***9@qq.com
deepin
2016-03-22 21:13
#11
https://bbs.deepin.org/post/38234
你卸的是啥,ath9k是内核自带的模块。。。。

我现在也不想其他的了,有没有办法把原来的驱动找回来呢
Reply View the author
avatar
lieri
deepin
2016-03-22 21:34
#12
试试sudo apt-get install firmware-atheros
Reply View the author
avatar
5***9@qq.com
deepin
2016-03-22 22:03
#13
https://bbs.deepin.org/post/38234
试试sudo apt-get install firmware-atheros

好了,谢谢
Reply View the author