[投票]大家登陆系统后多长时间桌面和dock加载完毕?
Tofloor
poster avatar
drecol
deepin
2017-02-19 03:36
Author
本帖最后由 drecol 于 2017-2-18 20:25 编辑

感觉deepin桌面的加载速度不快,我的电脑(机械硬盘)登陆后大概需要七秒桌面才全部加载完毕,然后才能正常开始使用(好烦啊),竟然和gnome差不多,,虽然dde的整体反应速度比gnome快了一点。加载完成前开软件都卡卡的。那么,大家登陆后桌面和dock需要几秒加载完?


(Expired, see the results below)
74 users voted
1.机械硬盘,2秒内(5 votes)
7 %
2.机械硬盘,2~4秒(1 votes)
1 %
3.机械硬盘,4~6秒(4 votes)
5 %
4.机械硬盘,6秒以上(29 votes)
39 %
5.固态硬盘 ,2秒内(14 votes)
19 %
6.固态硬盘 ,2~4秒(17 votes)
23 %
7.固态硬盘,,4~6秒(0 votes)
0 %
8.固态硬盘,6秒以上(4 votes)
5 %
Reply Favorite View the author
All Replies
avatar
drecol
deepin
2017-02-19 05:42
#1
comzhong 发表于 2017-2-18 20:53
7s还不算快啊,就目前来说,10s以内都算快的,过分追求速度,要么会增加许多不必要的工作量,要么会损失一 ...

我的7秒是指出现壁纸之后7秒加载完,实际上加上输完密码按回车之后几秒的黑屏,一共十秒往上了。虽然几秒不算什么,但就是很在意啊,感觉deepin还可以再优化
Reply View the author
avatar
185******04
deepin
2017-02-19 05:57
#2
https://bbs.deepin.org/post/135058
我的7秒是指出现壁纸之后7秒加载完,实际上加上输完密码按回车之后几秒的黑屏,一共十秒往上了。虽然几秒 ...

差不多了
Reply View the author
avatar
ghou
deepin
2017-02-19 07:22
#3
这个加载完标准是什么?
我按照 systemd-analyze time 来投票,4~5s (kernel) + 8~10s (userspace)
Reply View the author
avatar
drecol
deepin
2017-02-19 15:48
#4
ghou 发表于 2017-2-18 23:22
这个加载完标准是什么?
我按照 systemd-analyze time 来投票,4~5s (kernel) + 8~10s (userspace) ...

systemd应该是统计到lightdm开启就结束了。
标准是从输入密码按下回车到壁纸、dock都出现花费的时间
Reply View the author
avatar
welvanesharp
deepin
2017-02-19 19:01
#5
机械硬盘表示20秒才加载完……从输入密码按下回车,到桌面和dock显示完整
Reply View the author
avatar
zhanshime
deepin
2017-02-19 19:12
#6
zhanshime@zhanshime-pc:~$ systemd-analyze time
Startup finished in 8.181s (firmware) + 2.033s (loader) + 4.221s (kernel) + 7.992s (userspace) = 22.428s
Reply View the author
avatar
不避风云
deepin
2017-02-19 19:30
#7
不得半分钟?难道我用的是假电脑?
Reply View the author
avatar
tc25898
deepin
2017-02-19 20:26
#8
本帖最后由 tc25898 于 2017-2-19 12:28 编辑
zhanshime 发表于 2017-2-19 11:12
zhanshime@zhanshime-pc:~$ systemd-analyze time
Startup finished in 8.181s (firmware) + 2.033s (loade ...

Startup finished in 5.903s (Kernel) + 15.097s (userspace) = 21.000s 为啥你的信息显示的比我的要详细呢?10年的笔记本了。
Reply View the author
avatar
zhanshime
deepin
2017-02-19 21:30
#9
可能是我电脑是deepin单系统的原因吧
Reply View the author
avatar
zhanshime
deepin
2017-02-19 21:31
#10
https://bbs.deepin.org/post/135058
Startup finished in 5.903s (Kernel) + 15.097s (userspace) = 21.000s 为啥你的信息显示的比我的要详细 ...

可能是我电脑是deepin单系统的原因吧
Reply View the author
avatar
ghou
deepin
2017-02-20 04:20
#11
https://bbs.deepin.org/post/135058
可能是我电脑是deepin单系统的原因吧

不,是因为你用的 UEFI 启动,分析的时候会加上固件和启动引导器的时间
Reply View the author
avatar
ghou
deepin
2017-02-20 04:41
#12
https://bbs.deepin.org/post/135058
systemd应该是统计到lightdm开启就结束了。
标准是从输入密码按下回车到壁纸、dock都出现花费的时间 ...

我看到的官方统计解释,如果看 plot 或者其它 tree 形式的图可以看到,不是只到 lightdm (起码我机子上后面还有 network 相关的一些服务)

Note that these measurements simply measure the time passed up to the point where all system services have been spawned, but not necessarily until they fully finished initialization or the disk is idle.


如果是按你的说法,密码回车到dock出现,基本秒;如果是到dock加载完(因为会有不少开机自启项目服务会慢慢在dock显示图标),那就得几秒了。
Reply View the author
avatar
何来
deepin
2017-02-20 07:28
#13
2S内是肯定的
Reply View the author
avatar
黑色
deepin
2017-02-20 23:15
#14
固态盘,没感觉,X打开一秒左右就加载完了
Reply View the author
avatar
155******10
deepin
2017-02-21 21:39
#15
我个人使用的是ssd硬盘,读写450MB/S,装的软件很多,也创建了一大堆软连接,感觉从启动进入桌面到完全加载大约需要3-7S的样子,使用的i5的机器,6G内存
Reply View the author
avatar
a2035274
deepin
2017-03-25 01:36
#16
deepin@G470_deepin_15_4_bate:~$ systemd-analyze time
Startup finished in 10.794s (kernel) + 29.421s (userspace) = 40.216s
Reply View the author
avatar
158******91
deepin
2017-03-25 04:48
#17
$ systemd-analyze time
Startup finished in 4.910s (kernel) + 11.876s (userspace) = 16.786s
sata2的SSD,感觉有点慢
Reply View the author